FAQ: What do the operators <<, >>, &, |, ~, and ^ do?

These are Python's bitwise operators.

Preamble: Two's Complement Numbers

All of these operators share something in common -- they are "bitwise" operators. That is, they operate on numbers (normally), but instead of treating that number as if it were a single value, they treat it as if it were a string of bits, written in two's complement binary. A two's complement binary is the same as the classical binary representation for positive integers, but is slightly different for negative numbers. Negative numbers are represented by performing the two's complement operation on their absolute value. So a brief summary of two's complement binary is in order:

Two's Complement binary for Positive Integers:

• 0 is written as "0"
• 1 is written as "1"
• 2 is written as "10"
• 3 is "11"
• 4 is "100"
• 5 is "101"
• .
• .
• 1029 is "10000000101" == 2**10 + 2**2 + 2**0 == 1024 + 4 + 1

Two's Complement binary for Negative Integers:

Negative numbers are written with a leading one instead of a leading zero. So if you are using only 8 bits for your two's complement numbers, then you treat patterns from "00000000" to "01111111" as the whole numbers from 0 to 127, and reserve "1xxxxxxx" for writing negative numbers. A negative number, -x, is written using the bit pattern for (x-1) with all of the bits complemented (switched from 1 to 0 or 0 to 1). So -1 is complement(1 - 1) = complement(0) = "11111111", and -10 is complement(10 - 1) = complement(9) = complement("00001001") = "11110110". This means that negative numbers go all the way down to -128 ("10000000").

Of course, Python doesn't use 8-bit numbers. It USED to use however many bits were native to your machine, but since that was non-portable, since Python 3 ints are arbitrary precision. Thus the number -5 is treated by bitwise operators as if it were written "...1111111111111111111011".

Whew! With that preamble out of the way (and hey, you probably knew this already), the operators are easy to explain:

The Operators:

x << y

Returns x with the bits shifted to the left by y places (and new bits on the right-hand-side are zeros). This is the same as multiplying x by 2**y.

x >> y

Returns x with the bits shifted to the right by y places. This is the same as floor division of x by 2**y.

x & y

Does a "bitwise and". Each bit of the output is 1 if the corresponding bit of x AND of y is 1, otherwise it's 0.

x | y

Does a "bitwise or". Each bit of the output is 0 if the corresponding bit of x AND of y is 0, otherwise it's 1.

~ x

Returns the complement of x - the number you get by switching each 1 for a 0 and each 0 for a 1. This is the same as -x - 1.

x ^ y

Does a "bitwise exclusive or". Each bit of the output is the same as the corresponding bit in x if that bit in y is 0, and it's the complement of the bit in x if that bit in y is 1.

Just remember about that infinite series of 1 bits in a negative number, and these should all make sense.

Other Classes

One more point: Python allows operator overloading, so some classes may be written to allow the bitwise operators, but with some other meaning. For instance, operations on the Python set and frozenset types have specific meanings for | (union), & (intersection) and ^ (symmetric difference).

See Also

* BitManipulation * BitArrays

CategoryFaq